Large capacity SGMVV type servo motor.
Rated output: 45KW.
Voltage: three phase AC400V.
Serial encoder: 20 bit absolute value type.
Rated speed: 1500r\/min.
The main mechanical structure: support mounting type, straight shaft (no keyway and screw).
Optional parts: with hold brake (DC24V), with oil seal SGD7S-200A20A datasheet PDF catalog SGD7S-200A20A PDF datasheet.
The use of small, low inertia servo motor, also can give full play to the strength of the mechanical properties SGD7S-200A20A
The new model SGMVV with a rated output of 22~55KW, the amount of passenger speed 800r\/min and 1500r\/min products.
After the motor is installed, the phase is started to run immediately.
Even if the servo is not adjusted, as long as the moment of inertia is within the allowable range,
Even if the load changes, it can be driven stably, and the vibration will not happenNo speed reducer in inertia, high speed servo motor type SGM7J (rated speed 3000r\/min) SGD7S-200A20A datasheet PDF catalog SGD7S-200A20A PDF datasheet.
Rated output: 600W.
Power supply voltage: AC200V.
Serial encoder: 24 bit delta.
Design sequence: C.
Shaft end: straight shaft with keyway, with screw.
Optional parts: with oil seal, with the brake (DC24V).
Cantilever state and moment of inertia SGD7S-200A20A datasheet PDF catalog SGD7S-200A20A PDF datasheet.
After the change, can still maintain stable action.
Improvement of responsiveness.
Without adjustment, it can be achieved in the past about 2 times the response.
Improvement of stability.
The action is still stable for the presence of load fluctuations.
No gain adjustment.
Zero tuning time to ensure performance.
Protection system from the impact of temperature anomalies.
Servo unit and servo motor equipped with temperature sensor.
Monitor the temperature of the product directly through the sensor, as soon as possible to detect and prevent failure.
In addition, the temperature state of the system can be monitored by the machine controller, which is safe and secureEquipped with INDEXER functional type servo unit (kit type).
Maximum applicable motor capacity: 1.5kw.
Power supply voltage: three phase AC400V.
Interface: instruction selection and installation (linear servo motor).
Matching (hardware): base mounting type (standard).
Matching (software): standard.
Matching (parameter): standard.
Optional modules: INDEXER module.
Simple.
By programming and serial programming, easy implementation of motion control.
Can also be installed through the Windows environment support tool (SigmaWin+) easy to start.
The I/O module can be connected with the upper controller simply.
Smart.
To support the operation of the main purpose of the positioning operation based on the program table.
The maximum number of programmable positioning points to 256 points.
With extternal positioning, JOG speed table operation, the origin of reversion, rich features such as programmable signal output SGD7S-200A20A datasheet PDF catalog SGD7S-200A20A PDF datasheet.
I/O points for the input: 19 points, output: 16 points.
Speedy. SGD7S-200A20A datasheet PDF catalog SGD7S-200A20A PDF datasheet.
High speed and high precision positioning by combining with high performance V series.
Motion control can be realized without using motion controller.