No speed reducer in inertia, high speed servo motor type SGM7J (rated speed 3000r\/min).
Rated output: 600W.
Power supply voltage: AC200V.
Serial encoder: 24 bit delta.
Design sequence: C.
Shaft end: straight shaft with keyway, with screw.
Optional parts: with oil seal, with the brake (DC24V).
Cantilever state and moment of inertia SGD7S-330A30A datasheet PDF catalog SGD7S-330A30A PDF datasheet.
After the change, can still maintain stable action SGD7S-330A30A
Improvement of responsiveness.
Without adjustment, it can be achieved in the past about 2 times the response.
Improvement of stability.
The action is still stable for the presence of load fluctuations.
No gain adjustment.
Zero tuning time to ensure performance.
Protection system from the impact of temperature anomalies SGD7S-330A30A datasheet PDF catalog SGD7S-330A30A PDF datasheet.
Servo unit and servo motor equipped with temperature sensor.
Monitor the temperature of the product directly through the sensor, as soon as possible to detect and prevent failure.
In addition, the temperature state of the system can be monitored by the machine controller, which is safe and secureHigh performance, use the best type of servo unit (purpose type).
Maximum applicable motor capacity: 1 SGD7S-330A30A datasheet PDF catalog SGD7S-330A30A PDF datasheet. 5kw.
Power supply voltage: single phase AC200V.
Interface: MECHATROLINK-III communication instruction typeFull closed loop module.
Maximum applicable motor capacity: 5.0kw.
Power supply voltage: three phase AC200V.
Interface: MECHATROLINK- II communication command type (rotary servo motor).
Design sequence: A.
Hardware specifications: paint.
Matching (software): no matching (standard).
Matching (parameters): no matching (standard).
Optional modules: full closed loop module.
Full closed loop control system is used to control the rotating servo motor.
Please install the servo unit.
Using the position feedback signal which is output by the external encoder (linear grating ruler) installed on the side of the machine to realize the high precision and high response.
External encoder capable of corresponding high resolution (linear grating). Sigma -v series servo unit SGDV.
Maximum applicable motor capacity: 0.2kw.
Power supply voltage: single phase AC100V.
Design sequence: A type.
Interface: MECHATROLINK- II communication command type (linear servo motor).
Matching (hardware): base mounting type (standard).
Realize real time communication.
The maximum transmission speed of 10Mbps and can be set to the communication cycle 250 s ~ 4ms,
Achieved a maximum of 30 stations in the high speed control. Through the high speed of communication,
Can send and receive all kinds of control information in real time.
Energy saving and high efficiency.
A maximum of 30 stations can be connected to the communication lines, can significantly reduce the wiring costs and time.
The command connector of the upper controller only needs 1,
Pulse generator for D/A converter or positionn instruction without speed / torque command SGD7S-330A30A datasheet PDF catalog SGD7S-330A30A PDF datasheet.
High precision motion control is realized.
In addition to torque, position and speed control, but also to achieve high precision synchronizzation phase control SGD7S-330A30A datasheet PDF catalog SGD7S-330A30A PDF datasheet.
Because the control mode can be switched on line, the complicated mechanical action can be realized more effectively and smoothly.