Sigma -v series servo unit SGDV.
Maximum applicable motor capacity: 0.75kw.
Power supply voltage: single phase AC200V.
Design sequence: A type.
Interface: MECHATROLINK- II communication command type (linear servo motor).
Matching (hardware): base mounting type (standard).
Realize real time communication SGD7S-2R8A20A001 MECHATROLINK-III Communications Manual SGD7S-2R8A20A001 INSTRUCTION SHEET.
The maximum transmission speed of 10Mbps and can be set to the communication cycle 250 s ~ 4ms,
Achieved a maximum of 30 stations in the high speed control SGD7S-2R8A20A001 Through the high speed of communication,
Can send and receive all kinds of control information in real time.
Energy saving and high efficiency.
A maximum of 30 stations can be connected to the communication lines, can significantly reduce the wiring costs and time SGD7S-2R8A20A001 MECHATROLINK-III Communications Manual SGD7S-2R8A20A001 INSTRUCTION SHEET.
The command connector of the upper controller only needs 1,
Pulse generator for D/A converter or position instruction without speed / torque command.
High precision motion control is realized.
In addition to torque, position and speed control, but also to achieve high precision synchronization phase control.
Because the control mode can be switched on line, the complicated mechanical action can be realized more effectively and smoothly SGD7S-2R8A20A001 MECHATROLINK-III Communications Manual SGD7S-2R8A20A001 INSTRUCTION SHEET. Servo motor SGMDH type.
Rated speed: 3000r\/min.
Power: 4.0kw.
Power supply voltage: three phase AC200V.
Serial encoder: 17 bit relative value.
Design sequence: A.
Shaft end: straight shaft with screw key.
Optional parts: with oil seal.
Partial flat series: the need to install the servo motor in a small space.
Rich motor series.
Equipped with brake, belt reducer, such as a wealth of motor products.
Online automatic adjustment, automatic measurement of mechanical properties, set the required servo gain.
Even if the initial contact, can also be completed in a short time the best set.
Automatic iddentification of the motor, servo drive automatic identification of servo motor power, specifications, automatic setting motor parameters SGD7S-2R8A20A001 MECHATROLINK-III Communications Manual SGD7S-2R8A20A001 INSTRUCTION SHEET.
Standard for regeneerative resistance connection terminals SGD7S-2R8A20A001 MECHATROLINK-III Communications Manual SGD7S-2R8A20A001 INSTRUCTION SHEET.
Connecting terminal equipped with external regenerative resistance,
Convenient connection regenerative resistor