Sigma -V series servo motor SGMSV.
Rated output: 1.0kw.
Power supply voltage: AC400V.
Serial encoder: 20 bit absolute value type (standard).
Design sequence: standard.
Shaft end: straight shaft, without keyway (standard).
Optional: with hold brake (DC90V).
Super power rate.
Variety is complete (1.0kW ~ 7 SGDV-1R9D15A002FT003 MECHATROLINK-II Commands Manual SGDV-1R9D15A002FT003 USER'S MANUAL. 0kW, with hold brake) SGDV-1R9D15A002FT003
Equipped with a high resolution serial encoder (20 bit).
Standard using IP67 (7.0kw for IP22).
Use example:
Placement machine.
Punch printed circuit board.
Machine tool feeding device.
Rating and specifications:
Rated time: continuous.
Vibration level: V15.
Insulation resistance: DC500V, 10M, or above.
Using ambient temperature: 0 ~ 40 degrees C.
Excitation mode: permanent magnet type SGDV-1R9D15A002FT003 MECHATROLINK-II Commands Manual SGDV-1R9D15A002FT003 USER'S MANUAL.
Installation method: flange type.
Heat resistance grade: F.
Insulation withstand voltage: AC1500V 1 minutes (200V), AC1800V 1 minutes (400V).
Protection mode: fully enclosed self cooling type IP67 (except shaft through part).
The use of environmental humidity: 20 ~ 80% (not dew).
Connection mode: direct connection.
Rotation direction: clockwise direction (CCW) rotation at the load side under the direction of rotationServo motor SGMDH type SGDV-1R9D15A002FT003 MECHATROLINK-II Commands Manual SGDV-1R9D15A002FT003 USER'S MANUAL.
Rated speed: 3000r\/min.
Power: 4.0kw.
Power supply voltage: three phase AC200V.
Serial encoder: 17 bit relative value.
Design sequence: A.
Shaft end: straight shaft with screw key.
Optional parts: with oil seal.
Partial flat series: the need to install the servo motor in a small space.
Rich motor series.
Equipped with brake, belt reducer, such as a wealth of motor products.
Online automatic adjustment, automatic measurement of mechanical properties, set the required servo gain.
Even if the initial contact, can also be completed in a short time the best set.
Automaticc identification of the motor, servo drive automatic identification of servo motor power, specifications, automatic setting motor parameters SGDV-1R9D15A002FT003 MECHATROLINK-II Commands Manual SGDV-1R9D15A002FT003 USER'S MANUAL.
Standard for regeneerative resistance connection terminals SGDV-1R9D15A002FT003 MECHATROLINK-II Commands Manual SGDV-1R9D15A002FT003 USER'S MANUAL.
Connecting terminal equipped with external regenerative resistance,
Convenient connection regenerative resistor