Sigma -V series servo motor SGMSV.
Rated output: 3.0kw.
Power supply voltage: AC200V.
Serial encoder: 20 bit Delta (standard).
Design sequence: standard.
Shaft end: straight shaft with keyway, with screw (optional).
Optional: with oil seal.
Super power rate.
Variety is complete (1.0kW ~ 7.0kW, with hold brake) SGDV-590A11A003000 MECHATROLINK-II Commands Manual SGDV-590A11A003000 USER'S MANUAL.
Equipped with a high resolution serial encoder (20 bit) SGDV-590A11A003000
Standard using IP67 (7.0kw for IP22).
Use example:
Placement machine.
Punch printed circuit board.
Machine tool feeding device.
Rating and specifications:
Rated time: continuous.
Vibration level: V15.
Insulation resistance: DC500V, 10M, or above.
Using ambient temperature: 0 ~ 40 degrees C.
Excitation mode: permanent magnet type SGDV-590A11A003000 MECHATROLINK-II Commands Manual SGDV-590A11A003000 USER'S MANUAL.
Installation method: flange type.
Heat resistance grade: F.
Insulation withstand voltage: AC1500V 1 minutes (200V), AC1800V 1 minutes (400V).
Protection mode: fully enclosed self cooling type IP67 (except shaft through part).
The use of environmental humidity: 20 ~ 80% (not dew).
Connection mode: direct connection.
Rotation direction: clockwise direction (CCW) rotation at the load side under the direction of rotationEquipped with INDEXER functional type servo unit (kit type) SGDV-590A11A003000 MECHATROLINK-II Commands Manual SGDV-590A11A003000 USER'S MANUAL.
Maximum applicable motor capacity: 5.0kw.
Power supply voltage: three phase AC400V.
Interface: instruction selection and installation (rotary type servo motor).
Matching (hardware): paint.
Matching (software): standard.
Matching (parameter): standard.
Optional modules: INDEXER module.
Simple.
By programming and serial programming, easy implementation of motion control.
Can also be installed through the Windows environment support tool (SigmaWin+) easy to start.
The I/O module can be connected with the upper controller simply.
Smart.
To support the operation of the main purpose of the positioning operation based on the program table.
The maximum number of programmable positioning points to 256 points.
With external positioning, JJOG speed table operation, the origin of reversion, rich features such as programmable signal output SGDV-590A11A003000 MECHATROLINK-II Commands Manual SGDV-590A11A003000 USER'S MANUAL.
I/O points for the input: 19 points, output: 16 points.
Speedy. SGDV-590A11A003000 MECHATROLINK-II Commands Manual SGDV-590A11A003000 USER'S MANUAL.
High speed and high precision positioning by combining with high performance V series.
Motion control can be realized without using motion controller.